Thingiverse
Thor Hammer Keychain
von timmy_d3
3.3k
Downloads
2.9k
Likes
30
Makes
UPDATE: Check out my updated and more print-friendly version of the design at https://www.thingiverse.com/thing:4240269
This is a basic keychain of Thor's hammer (Mjolnir). It's a normal size for a keychain, though it still has good strength and durability.
I would recommend printing it sideways with the Asgard emblem facing up. Print with supports for the handle, as it will start about halfway through the print. I did mine with 30 percent infill and 0.1mm layer height. No raft.
For paint I just used metallic silver spray paint and a non-gloss brown enamel spray paint. I used painters tape to separate segments, no hand painting needed.
Hope y'all enjoy. Please share pictures if you make on!
This is a basic keychain of Thor's hammer (Mjolnir). It's a normal size for a keychain, though it still has good strength and durability.
I would recommend printing it sideways with the Asgard emblem facing up. Print with supports for the handle, as it will start about halfway through the print. I did mine with 30 percent infill and 0.1mm layer height. No raft.
For paint I just used metallic silver spray paint and a non-gloss brown enamel spray paint. I used painters tape to separate segments, no hand painting needed.
Hope y'all enjoy. Please share pictures if you make on!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
