MakerWorld
Hueforge & Lithophane
Zum Modell
Thor
14
Downloads
18
Likes
14
Makes
Project: ThorPrint at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmThe Model is 200x200mm in sizeYou may print at higher layer heights below the Min Depth of 0.64mmThe Max Depth is 2.2mm and the Actual Depth is 2.2mm This print uses 7 unique filamentsPLA BambuLab Basic Black PLA BambuLab Basic Maroon Red PLA BambuLab Basic Blue Gray PLA BambuLab Matte Mandarin OrangePLA BambuLab Basic Yellow PLA BambuLab Matte Ivory White PLA BambuLab Matte Ice BlueSwap Instructions:Start with BlackAt 0.8mm swap to Maroon RedAt 1.12mm swap to Blue GrayAt 1.36mm swap to Mandarin OrangeAt 1.6mm swap to YellowAt 1.76mm swap to Ivory WhiteAt 2.08mm swap to Ice Blue for the rest.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
