Thingiverse
Threaded Crystal Egg made for Vase Mode
by 3DDrucker247
11
Downloads
44
Likes
0
Makes
This model is a remix of WF3D’s Crystal Egg available on Printables (https://www.printables.com/model/160757-crystal-egg), modified to incorporate a threaded joint at the center, inspired by ViperXT's Threaded Crystal Egg (https://www.printables.com/model/445665-threaded-crystal-egg).
To achieve a high-quality surface finish, the egg has been hollowed out and a narrow slit has been introduced along selected facet edges. This design forces vase mode to generate exactly two continuous perimeters throughout the model. As a result, the model is well suited for printing with large nozzle diameters (tested up to 1.2 mm).
The STL features a uniform wall thickness of 2.0 mm and is optimized for a line width of 1.0 mm, producing an egg with a total height of 151 mm. When using a 0.4 mm nozzle, good results were achieved with a line width of 0.6 mm and scaling the model to 50%.
For best results, adaptive layer height and appropriate minimum layer time settings are recommended to ensure clean
To achieve a high-quality surface finish, the egg has been hollowed out and a narrow slit has been introduced along selected facet edges. This design forces vase mode to generate exactly two continuous perimeters throughout the model. As a result, the model is well suited for printing with large nozzle diameters (tested up to 1.2 mm).
The STL features a uniform wall thickness of 2.0 mm and is optimized for a line width of 1.0 mm, producing an egg with a total height of 151 mm. When using a 0.4 mm nozzle, good results were achieved with a line width of 0.6 mm and scaling the model to 50%.
For best results, adaptive layer height and appropriate minimum layer time settings are recommended to ensure clean
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
