Throttle Fixture

********* NOTE *********

I designed this build and it worked quite well however I have since replaced this design with those designed by Vince_Prints: https://www.thingiverse.com/Vince_Prints

********* NOTE *********

Cessna 172 throttle fixture for linear potentiometer. This fixture is designed to be mounted behind a panel to allow for the throttle rod to push/pull against the linear pot. When printing this I highly recommend that you mask for 100% fill on the front flange section. This will allow you to drill out all holes to the size rod you are using.

The throttle knob is by allenglen: https://www.thingiverse.com/thing:2720384

Slide potentiometer: https://www.ebay.com/itm/B100K-Ohm-Slide-Potentiometer-Stereo-128mm/382432965929?hash=item590ac7f529:g:tgMAAOSwCQNWg2vH

The ebay link above is for part reference only. I am not selling the potentiometers


I have added another part to this system. The "block" will allow you to set a stop on the travel of the pot.