Through Girder Bridge - HO Modular

The elements of this HO modular through girder bridge can be assembled to make an angled (as I did) or straight bridge of any length. There's also a short truss for adjusting the length to less than one truss section. Print out the trusses, then attach the inside sides, then the outside sides are laminated to them. Make sure the joints don't meet up and the bridge will end up quite strong. The inside panels have ribs that aren't any thicker than the raised borders of the panel. The outside panels have ribs that are thicker than the raised border of the panel. I used ACC glue and it worded quite well. Good luck. Don't hesitate to write if you have questions.