Thingiverse
Through Shelf Filament guide
door Thomllama
6
Downloads
9
Likes
0
Makes
just a simple plug/guide for the filament if you want to have your spool above the printer and feed down through a shelf above. 5/8ths and 1/2 inch diameter and set up for 3/4" shelf material.. but shouldn't have an issue with anything 1/2-5/4 (1 1/4") shelf thickness
there is a slight taper both top and bottom in the center so edge drag should be eliminated for the most part.
there is a slight taper both top and bottom in the center so edge drag should be eliminated for the most part.
Thomllama publiceert ook op
154 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!