Thrustmaster MFD Cougar mount

I did this remix because the monitor used in the original design was unavailable, the print was too big for my printer and I had a different desk mount.

### Stuff I bought

Monitor used: [WIMAXIT 11.6"](https://wimaxit.com/collections/11-6-inch/products/wimaxit-m1160s-portable-monitor) [Amazon](https://www.amazon.co.uk/dp/B07L3NLL2T)
Dimensions: 284mm x 182mm x 16mm (not 14mm as advertised!). The case is a piece of sheet metal folded over so you can expect measurements to be out slightly.

HOTAS mount used: [Hikig mount for Logitech X56](https://www.amazon.co.uk/dp/B093BWS3VB)
Dimensions: 60mm wide and 90mm deep. 20mm wide extrusions.

[Thrustmaster MFD Cougar](https://www.thrustmaster.com/en-gb/products/mfd-cougar-pack/)

### Measurements worth noting

- VESA 75 holes are 52mm from bottom edge to hole edge, and 102mm from side edge to hole edge.
- The monitor depth gap is 16mm

### Screws needed:

4 x M3 16mm countersunk - for attaching the MFD to the mount
4 x M