Thrustmaster T-series Quickrelease thing

Check out my new Hub and adapter instead: https://www.printables.com/model/1272216-thrustmaster-t-series-nrg-quickrelease

*********************************************************************************************************************************************

I did not want adapter on adapters to use the slim quick release on my Thrustmaster TX base, so I designed this thing that go right on the metal axle on the TX base and you screw the quick release directly to this thing and your good to go.

I designed it with 70mm bolt pattern, same as momo, omp and sparco etc..

I printed it out in PC (polycarbonate) just to be sure that it can handle all the hard racing, but ABS should be good enough.

Remove the innerpart of the thrustmaster adapter with the 4 screws that goes into the axle, If your unlucky like me and they brake, I designed in two M5 holes on the two sides of it, you can then use a 4,2 drillbit and make holes on two of the sides, and then make M5 threads so you can use