Thrustmaster T3PA hall sensor mount

Simple hall sensor mod for T3PA pedals from TMaster.
Sensor is fixed in position, with two neodimium magnets 10x10x3 orbiting around.
I think that with this solution you can't use full hall resolution, but i found this gave me a pretty linear response on pedal rotation, unlike positioning 2 magnets side by side rotating over the sensor along an arc.

The mod use the original potentiometer as rotation axle and the opposite two hole in the frame for sensor support.
Sensor is a common linear 49E, also needed is a short M3 screw and nut to fix in place the sensor support. And the two magnets obviously, i used two 10x10x3mm magnets from Amzn.
Magnet support is split in 2 part for easy setup, once you find the correct position, you can fix in place with some glue.

IMPORTANT: i use this mod with an Arduino interface, NOT the original TMaster software.

Project is "in progress", as i'm currently testing it.