Thingiverse
Thumbscrew Cap For M8 Socket Head Capscrew
von Bob-D
34
Downloads
11
Likes
0
Makes
I created this cap to use a M8 socket head capscrew as a thumbscrew.
It is a press fit so no glue needed. This lets you easily revert back to original configuration and at the same time it is a snug enough fit that it will not come off during use.
I printed solid as the walls are thin and it is a tiny part that takes less than 30 minutes to print.
It is a press fit so no glue needed. This lets you easily revert back to original configuration and at the same time it is a snug enough fit that it will not come off during use.
I printed solid as the walls are thin and it is a tiny part that takes less than 30 minutes to print.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!