Thingiverse
Thumbstick Cap PS4
door fikus
1
Downloads
6
Likes
0
Makes
# Thumbstick Cap PS4
I made this becouse my joystick became sticky so i needed to cover them up. But at the same time i didnt want to raise them up too much.
On the original file ton of people complained that the cap is rubbing on the controller.
So i shortened it by 1mm and uploaded it and also shortened the original one. But printing the original one in TPU isnt the best becouse of the overhang.
## Compatibility with other controllers
- The taller one when printed in TPU also fits on Dualshock 3.
- It is slightly too big for Dualsense.
- Xbox One controller has much smaller joystick so it doesnt fit.
I made this becouse my joystick became sticky so i needed to cover them up. But at the same time i didnt want to raise them up too much.
On the original file ton of people complained that the cap is rubbing on the controller.
So i shortened it by 1mm and uploaded it and also shortened the original one. But printing the original one in TPU isnt the best becouse of the overhang.
## Compatibility with other controllers
- The taller one when printed in TPU also fits on Dualshock 3.
- It is slightly too big for Dualsense.
- Xbox One controller has much smaller joystick so it doesnt fit.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!