Thingiverse
Thumby Case
by John_Wet
14
Downloads
16
Likes
0
Makes
A simple case for the adorable Thumby!
IMPORTANT PRINT INFORMATION:
- print it vertically
- there is no need for supports, just clean up the print a little with a knife or pliers
- make sure the z- seam is not located on the hinge
- make sure the hinge is printed without stopping between the two halves (see picture)
If you don't check these things beforehand, the hinge will not be durable enough.
IMPORTANT PRINT INFORMATION:
- print it vertically
- there is no need for supports, just clean up the print a little with a knife or pliers
- make sure the z- seam is not located on the hinge
- make sure the hinge is printed without stopping between the two halves (see picture)
If you don't check these things beforehand, the hinge will not be durable enough.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!