Thunder Nightlamp

A lightning lamp printed from PLA. It used an COD LED strip from Amazone: https://www.amazon.de/dp/B0CSFRFGNF?psc=1&ref=ppx_yo2ov_dt_b_product_detailsIt than is cut into smaller pieces und glued on to the back plate of the cloud und thunder. After glued it was soldered togehter until the backplate is complety covered.Of course you can use every other LED strip, just be aware of length of the possible cuts and that you can power the LED strip perfectly.Because the LED strip i use only need +5 VCC and GND. Therefore on the bottom one GND and +5 VCC is soldered to the cable of the controller. The glue used in this project is 'UHU Allplast', it can be found on Amazon. But other glue for 3D printing will also probably work. To solder the single strips together i used 0.14mm² copper wire. Any questing i will answer asap. Importent: If you will not use the printer profile, print all parts with 100% infill. If not you can have shadows of the infill pattern inside you parts. The ‘thunde