Thingiverse
THWUDD! -- THWACK! Mallet Edition
by Strother
51
Downloads
23
Likes
0
Makes
The round and square pieces are intended to turn THWACK! into a rubber mallet by printing them in a flexible filament and popping them onto the ends of the hammer.
They will also prolong the life of the hammer by allowing you to just reprint the pieces when they wear out as opposed to printing an entirely new hammer.
Thanks to [Mr_MegaTronic](http://www.thingiverse.com/Mr_MegaTronic/about) for creating the original version of this spool holder.
They will also prolong the life of the hammer by allowing you to just reprint the pieces when they wear out as opposed to printing an entirely new hammer.
Thanks to [Mr_MegaTronic](http://www.thingiverse.com/Mr_MegaTronic/about) for creating the original version of this spool holder.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
