Slicer Discord
Tic-Remover – 3D-Druckmodell von Thingiverse Thingiverse

Tic-Remover

von Bondeus
211 Downloads
214 Likes
4 Makes
Zum Modell
This is a handy tool to remove annoying tics from your pet. Grab the tic by sliding the two arms around it until it get gripped well, then rotate the handle with your fingers and the tic lets got quite easy. Normally I have been removing tics with my fingers but it is very hard to get all of the tic out and this could lead to inflammations.
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen