Slicer Discord
Tick Tool Tweezers Picker Fast – 3D printable model from MakerOnline MakerOnline
Tools

Tick Tool Tweezers Picker Fast

235 Downloads
64 Likes
0 Makes
Go to Model
Hello everyone, this time it has become a pair of tick tweezers “due to the season”. Due to the warm and humid weather in Germany, the ticks are very bad at the moment.   It prints quick and uses little material!   To properly remove a tick, follow these steps (by ChatGPT): Pull Upward with Steady, Even Pressure: Avoid twisting or jerking the tick, which can cause the mouth-parts to break off and remain in the skin. Clean the Bite Area: After removing the tick, clean the bite area and your hands with rubbing alcohol, an iodine scrub, or soap and water. Dispose of the Tick Properly: Place the tick in alcohol, a sealed bag/container, or flush it down the toilet. Do not crush it with your fingers. Monitor for Symptoms: Watch the bite area for signs of rash or infection, and seek medical advice if you experience fever, chills, or other symptoms. It's important to remove the tick as soon as possible to reduce the risk of disease transmission.   Have fun with it and as always, be cool to each other!   Cheers, Marcel <3
Category
Tools
Source
MakerOnline
Published
What you need to print this: Beginner Low confidence
Single piece
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 0/3
Printer
FDM / FFF
File format
STL
Material
PLA
Software
Cura, PrusaSlicer, or similar
No ratings yet
No comments yet – be the first!

Similar Models

6 Suggestions
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection