Thingiverse
Tie Advanced X1
door Landru
3.8k
Downloads
2.6k
Likes
93
Makes
This is a detailed (though not immensely accurate) model of the Imperial Tie Advanced X1 - Darth Vader's Tie Fighter
It is fully printable, without any nasty overhangs, bridges, etc.
Also, there are alignment pegs for assembling the two halves.
The model shown was printed on a Fablicator
www.Fablicator.com
I stumbled upon Chanson's detailed Solidworks model over on grabcad, and did some very heavy modification to make it printable, while maintaining as much detail as possible. Original can be found here: http://grabcad.com/library/darth-vaders-tie-fighter
It is fully printable, without any nasty overhangs, bridges, etc.
Also, there are alignment pegs for assembling the two halves.
The model shown was printed on a Fablicator
www.Fablicator.com
I stumbled upon Chanson's detailed Solidworks model over on grabcad, and did some very heavy modification to make it printable, while maintaining as much detail as possible. Original can be found here: http://grabcad.com/library/darth-vaders-tie-fighter
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
