TIE Fighter in Flight

Here's another beautiful (if I may say so myself) HueForge Hybrid print for you!     I used Burnt Titanium for the 'space blue' and it turned out magnificently, but you can use whatever you feel like, honestly! Same goes for the material for the TIE Fighter. I just wanted to try out the Metal PLA that Bambu sent me :) An AMS is not needed for this, however will make it easier. If you do not have an AMS, just manually swap out the filament spools at the right layer (adding a pause in the slicer where you would change colours)     This print takes 3 hours on the Bambu Lab P1P and is completely printed in place, without supports. If you are using a Bambu printer or Bambu studio, the 3MF will have all the necessary settings you need. If not, please download the STL and follow the instructions below!     Print Instructions: HueForge section of the print (0.00mm - 2.00mm) - Print at 100% infill with a layer height of 0.04mm with a base layer of 0.24mm     TIE Fighter part of the print (2.04mm - 64.44mm) - Print at 0.16mm layer height, with 2 walls, 3 tops and 3 bottom surfaces - I used 5% gyroid infill.     Filaments Used: - PLA Kingroon Black Transmission Distance: 0.4 - PLA Flashforge Burnt Titanium Transmission Distance: 5 - PLA CC3D Lemon Yellow Transmission Distance: 8 - PLA BambuLab Basic Jade White Transmission Distance: 5 - PLA Bambulab Metal Iron Gray Transmission Distance: 0.6 (or the TIE Fighter!)     Swap Instructions: - Start with Black - At layer #23 (1.04mm) swap to Burnt Titanium (for the space background, but you can use anything!) - At layer #27 (1.2mm) swap to Lemon Yellow - At layer #39 (1.68mm) swap to Jade White - At 2.00mm swap to Bambulab Metal (for the TIE Fighter!)     The TIE model itself can be found found here :)