Thingiverse
TIE Fighter
von AbocAbac
114
Downloads
72
Likes
0
Makes
This is a "TIE Fighter" obtained by laser cutting.
Designed with Inkscape and Draftsight
Cut out of 6mm thick material (I used MDF + varnish).
Final dimensions : ~7x6cm.
Not suitable for children under 3 years due to small parts.
It is better to glue this model.
Lasercut layer order :Layer order :
0 = indication only
10 = LIGHT BLUE = engraving inside the contour
20 = RED = marking
30 = YELLOW = CUTTING
35 = PURPLE = CUTTING
40 = LIGHT GREEN = CUTTING
50 = DARK BLUE = CUTTING
60 = GREY = CUTTING
70 = DARK GREEN = CUTTING
Designed with Inkscape and Draftsight
Cut out of 6mm thick material (I used MDF + varnish).
Final dimensions : ~7x6cm.
Not suitable for children under 3 years due to small parts.
It is better to glue this model.
Lasercut layer order :Layer order :
0 = indication only
10 = LIGHT BLUE = engraving inside the contour
20 = RED = marking
30 = YELLOW = CUTTING
35 = PURPLE = CUTTING
40 = LIGHT GREEN = CUTTING
50 = DARK BLUE = CUTTING
60 = GREY = CUTTING
70 = DARK GREEN = CUTTING
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
