Thingiverse
Tie Hanger
von mohamedhijazi22
2
Downloads
5
Likes
0
Makes
It's a tie hanger. fits 12 ties. closed the sides compared to the original design to add rigidity and the holes to save on material.
it's a bit too strong for its need. material can be reduced on the horizontal slits from 80mm to 40mm or use minimal infill. My print I believe was at 5% or 10% infill.
might be scaled up by 10 on accident.
it's a bit too strong for its need. material can be reduced on the horizontal slits from 80mm to 40mm or use minimal infill. My print I believe was at 5% or 10% infill.
might be scaled up by 10 on accident.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
