Thingiverse
Tie MK II
door cevlost
109
Downloads
54
Likes
0
Makes
Tie MKII based off of the Tie and concept art from the Mandalorian (landing capable)
I have not gotten a way to hinge the wings but likely they would flop over.
This has been remixed from here https://www.thingiverse.com/thing:3035348
To print you need 2 of each wing piece (for left and right wing obviously)
1 of each landing gear and yes they do matter where they go.
1 fusalage
2 caps
To assemble:
Glue the 8 wing halves together:
Creates 2 flight wings
Creates 2 Landed position wings.
use 3MM x 2.5MM (0.125in x 0.95) (ish) magnets
Expect wobbly results due to magnet strength (i ended up gluing mine)
Print is untested in this stage (mine had more magnet holes)
I have not gotten a way to hinge the wings but likely they would flop over.
This has been remixed from here https://www.thingiverse.com/thing:3035348
To print you need 2 of each wing piece (for left and right wing obviously)
1 of each landing gear and yes they do matter where they go.
1 fusalage
2 caps
To assemble:
Glue the 8 wing halves together:
Creates 2 flight wings
Creates 2 Landed position wings.
use 3MM x 2.5MM (0.125in x 0.95) (ish) magnets
Expect wobbly results due to magnet strength (i ended up gluing mine)
Print is untested in this stage (mine had more magnet holes)
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
