Thingiverse
Tiertime Bed leveller
door Fallout1964
1
Downloads
0
Likes
0
Makes
Print 3 x components- Arm, knob and hex Plug
Items req'd: M6 bolt and nut, m4 nut, Dial indicator
remove print head by disconnecting flat cable and removing the m4 bolt under front left of the head.
Insert levelling tool into printhead socket and use the M4 screw to fasten down.
Using the Software/calibration page- RESET first ! then move the head around, adjust lower bed screws until done
https://www.youtube.com/shorts/NiEhBkCiXO0
Items req'd: M6 bolt and nut, m4 nut, Dial indicator
remove print head by disconnecting flat cable and removing the m4 bolt under front left of the head.
Insert levelling tool into printhead socket and use the M4 screw to fasten down.
Using the Software/calibration page- RESET first ! then move the head around, adjust lower bed screws until done
https://www.youtube.com/shorts/NiEhBkCiXO0
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!