Tig Torch Holder

This is a holder for a tig torch. It holds my 26 and 17 tig torches. I screwed a piece of half plywood to the bottom and glued magnets into the plywood. The support in the center is really thin you can cut it away with a utility knife. The post in the back are to hold extra tig cups. I may change these post to just a melted in hex bolt. This was created on Tinkercad and sliced through Cura 4.6, I used 20% infill with a cubic pattern, 2 mm wall and no raft. No other setting where changed from Cura's regular settings.