Thingiverse
Tighter - Yet Another Utility Knife
by lostinacrowd
8
Downloads
4
Likes
0
Makes
The cap was too thin for me and the inner and outer radii weren't concentric so there was a gap in the walls. I fixed that and thickened it up.
The blade rattled around in most directions. Maybe my blades are thinner than most? I tightened up the the holder so it would hold the blade better.
SW files here too for what it's worth.
*******************************************
A useful hobby knife that uses a standard utility blades.
Blade can be reversed when it becomes dull; therefore, doubling the life of it.
No additional hardware needed.
No support material is required.
Warning:
Be careful when pulling out protective cap.
This is a cutting tool that must be used with caution, please keep out of reach of children
The blade rattled around in most directions. Maybe my blades are thinner than most? I tightened up the the holder so it would hold the blade better.
SW files here too for what it's worth.
*******************************************
A useful hobby knife that uses a standard utility blades.
Blade can be reversed when it becomes dull; therefore, doubling the life of it.
No additional hardware needed.
No support material is required.
Warning:
Be careful when pulling out protective cap.
This is a cutting tool that must be used with caution, please keep out of reach of children
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!