Thingiverse
Tilt Case
von natko
4
Downloads
2
Likes
0
Makes
Case for tilt printer, designed for gen 3 electronis though 1/16 stepping will make nice hum noise rather than load noise i got.
Sorry its a router job, 4mm thick x 1200mm x 600mm sheet needed and designed for ITX PSU
And this will change when got build platform sorted.
Sorry its a router job, 4mm thick x 1200mm x 600mm sheet needed and designed for ITX PSU
And this will change when got build platform sorted.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
