TILT-N-TRAP (MOUSE TRAP) v02

I found this genius design by @2ROBOTGUY and printed two before I figured out why the hinge is so difficult to get a smooth action.

I did three fixes:

1) removed the tray. It was separated by a tiny gap, but my printer merged it. First I removed it with a saw, then I used blender. ;-)

2) Added a perimeter ledge to the hinge pin so it clicks in and won't come out. Make sure that the inside of the ring and the hinge pin are de-burred and smooth before you put them together because it requires squeezing the split pin to remove it. Apply some cooking oil or something non-synthetic smelling to lubricated it.

3) the ring of the hinge was overlapping with the edge of the base tube. So it was squeezing the hing pin, and not allowing a gap between the base and the hing pin. So if you spread the split as @2ROBOTGUY says, it scrapes and binds on the base tube. So I pulled the ring away from the tube, leaving a gap between the pin and the base tube.

The mice would get caugh