Timemore Slow Feeder

Here’s my take on a slow feeder for the Timemore Sculptor 064.It uses an on/off toggle switch, a PWM controller for variable speed control, a USB-C charging module on the back, a 14500 Li-ion 800 mAh battery, and a mini N20 gear motor. Everything is housed in a custom 3D-printed enclosure. Takes about 5 Hrs to printPrint the Feeder Disk in PETG. Assembly InstructionsMotor Installation:To insert the motor, slide it in about halfway, then press it firmly into the side clips.It’s designed to be a tight, secure fit, so push until it fully snaps into place.Battery Installation:Push the 14500 Li-ion cell into the printed battery clips.It should click in snugly and sit firmly without wobble.USB-C Charging Module:The USB-C charger module installs the same way—align it with the printed slot, push it in, and it will snap into the retaining clips.Feeder Disk:Push the bearing into placeBill Of Materials 1. SPST Toggle Switch2. 14500 Li-ion 800 mAh Cell Battery3. AliExpress – PWM Motor Speed Contro