Tiny 3D Pacman Fridge Magnets

WAKA - WAKA - WAKA
Here comes Pacman and Inky, Pinky, Blinky & Clyde - for your fridge!
And I added a scared ghost as well, just in case Pacman finds a super-pill in the fridge...

Each model is made out of at least two parts and a Ø6x3mm magnet. Print the parts, put them together, use glue if necessary. If the fit is too tight, try scaling the models in your slicer.

The models are quite small so this will be a challenging print. These are my settings on a Fab 2 Mini:
0.06 layer height
0.8 shell
20 mm/s print speed (10 for outer walls)
support on

PS:
I also added an assembled STL-part for each model, just in case you do not like the multi-part models. Then you only have to print one part and can paint the model later.


Disclaimer:
This work by blecheimer is licensed under CC BY-NC-SA 4.0.
You are not allowed to copy this model to other 3D printing websites without my permission.