Tiny Hawk II Freestyle add ons

Arm protectors that slide on the frame to protect it and the screws that mount the motors. All 4 are the same. Also XT30 holder that screws on the back using the existing screws. Printed all mine in PETG 100% infill supports everywhere on the arm protectors and supports touching build plate for XT30 holder. When put into my slicer i need to scale up to 1000% so double check your scale before printing.

6-29 Added a different style XT30 holder. It screws on the back and replaces the two frame standoffs. Sits at about a 45 deg angle. Print with supports everywhere maybe a little on the slower side I did 35

7-5 Added another arm guard that has a hump on it to keep from sliding or falling off in a crash. However needs to be printed in Flexible filament. still need supports everywhere for the over hang

9-20 Updated rear piece to allow antenna wires to be ran through a couple holes. small lower holes are to tie down motor wires if need be.