Thingiverse
Tiny Hoop 52mm frame
por PMantix
1
Descargas
4
Likes
0
Makes
A 52mm Tiny "Hoop" frame concept I've been working on.
This one was designed to fit motors with the shafts inverted, but it may still work OK for regular motors.
For these printed frames I never use grommets for the flight controller, I just hard mount the FC to the frame. Works fine!
The thru holes for mounting hardware are undersized by design so you'll want to thread them yourself by running a screw or bolt through each hole prior to assembly.
The compactness of the 52mm design means you'll need to be careful about the props hitting anything. Be sure to tuck wires below the prop locus , etc. I also included a quick canopy design for a Tiny Whoop Pinch cam that puts the camera near the center of the frame and avoids obstruction with the prop. As printed, I cut the rear mounting point off and just mount to the front, left, and right FC posts.
Enjoy!
This one was designed to fit motors with the shafts inverted, but it may still work OK for regular motors.
For these printed frames I never use grommets for the flight controller, I just hard mount the FC to the frame. Works fine!
The thru holes for mounting hardware are undersized by design so you'll want to thread them yourself by running a screw or bolt through each hole prior to assembly.
The compactness of the 52mm design means you'll need to be careful about the props hitting anything. Be sure to tuck wires below the prop locus , etc. I also included a quick canopy design for a Tiny Whoop Pinch cam that puts the camera near the center of the frame and avoids obstruction with the prop. As printed, I cut the rear mounting point off and just mount to the front, left, and right FC posts.
Enjoy!
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
