Slicer Discord
Tiny Travel Screwdriver – Modelo 3D imprimible de MakerWorld MakerWorld
Hand Tools

Tiny Travel Screwdriver

145 Descargas
65 Likes
81 Makes
Ver Modelo
What it isA tiny screwdriver, storing seven 4mm Micro Bits and attachable to a keyring or string on your gear. → Be prepared for that single or few screws that casually pop up, trying to ruin your day.The forces induced by the applied torque are spread over a large area by the stored bits, stripping a screw is no problem with this design.How to printRecommended for printing is a 0.2 mm layer height and a 0.4mm nozzle or finer. The version in the pictures is printed with these settings in PETG.My 4mm bits varied quite a bit depending on the vendor, some scaling may be required to get a nice fit (100% to 103% in xy is reported back so far). - There also is a separate negative volume modifier for the cut out of the central driver in use.If your bits are noticeably shorter or longer than 28mm, you may have 25mm or 30mm long variants. Use the provided alternate parts in that case.If your bits are rattling lengthwise, there are optional cushioning pads available to eliminate that (TPU advise
Categoría
Hand Tools
Fuente
MakerWorld
Publicado
Actualizado
Lo que necesitas para imprimir: Intermedio Confianza media
¿Por qué?
capas de 0.20mm
Pieza única Tornillería requerida
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 1/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
PETG, TPU
Cama mín.
50 mm (Pequeño)
Altura de capa
0.2 mm
Postprocesado
Tornillería
Software
Cura, PrusaSlicer o similar
Mismo diseñador, más plataformas

AMTprojects también publica en

31 modelos adicionales en 1 plataformas más

Verificado por coincidencia de títulos de modelos entre plataformas.
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección