Tiny Whoop 20 deg FIXED angle

Ever get tired of your camera angle not holding its fixed angle? well this design should resolve that. the base and walls that hold the camera in place are a fixed 20 degrees which should eliminate the sag that happens from all other mounts. if printed in nylon or TPU it should weigh around 0.5g without camera. i haven't tested this yet because my printer is down, but i'll edit this description once i get one printed in a few days.

i cut out as much material as i could to lighten the load mass. let me know thoughts or ideas or any revisions you think would benefit this design. all walls are 1mm thick FYI.