Tiny Whoop Beta 65s Low Profile camera mount

UPDATE:
V2 adding more support as I broke mine during a race. That a a a little chunk I took out that lines up with a chip on the camera so it sits a little better. Also, I'd suggest printing in PETG if you have it.

Just upgraded my Tiny Whoop to the Beta 65 frame and motors. The frame is a bit different so I created another low-profile mount to work with this frame. Camera is at a 25 degree angle, however, because of the way the frame is, it's probably more like 30-35. If you want to keep it at 25, then you'll need to trim the frame a bit. I thought that was better than putting a hump in this camera mount.

This has the AKK A5 camera on it which is a hair under 14 mm wide. You could probably fit a 15mm wide camera here between the hoops, but not much more. To attach the camera, I just use a little square of VHB (3m mounting tape... it holds insanely strong)