Tiny Whoop Minimalistic Camera Mount

This is a whoop canopy and camera mount that I designed after breaking my previous one. It is designed around a Blade Inductrix FPV frame, 40mm flight controller, and camera. It mounts using only the front and back holes on the frame.

The mount holds the camera at about a 15 degree angle. I made sure to allow enough room for the VTX to be mounted with double sided foam tape in the middle. I added a hole and support to run the VTX antenna through. The newest version has Chamfers on the bottom to help with elephants foot.

I have used foam tape foam tape in other areas to mount the flight controller because I lost some of the screws and didn't feel like going through the hassle of getting new ones. Right now I am using a 3D printed frame that I found on Thingiverse that seems to be holding up to the few crashes I have had so far.

Please comment if you have any questions, concerns or requests.