Thingiverse
tiny whoop motor bumpers
door danielstinebaugh
12
Downloads
16
Likes
0
Makes
Wanted to use the super light acro frame that i printed in carbon fiber pet-g, but also wanted to use my carbon fiber x brace's as they really do help so much, but they don't fit on bare motors, and I also am still very new to multi-rotors, so crash's do happen often, and I wanted to protect the wires as well on these tiny 6mm brushed motors the Tiny Whoops use.
So I designed and printed these "bumpers" for the bottom of the motors.
Small pin to keep from bottoming out, and just enough space that the wires fit.
so far this design has worked and fit great! (Only took 5 revisions!)
Too small? over-extrude. Too tight? under-extrude. Tolerances are that tight this small.
(photos at the end show the difference in weight from the "cockroach" frame from newbeedrone (which I love) and the acro frame which you'll note does already have the carbon fiber x-brace installed and still comes in lighter!
So I designed and printed these "bumpers" for the bottom of the motors.
Small pin to keep from bottoming out, and just enough space that the wires fit.
so far this design has worked and fit great! (Only took 5 revisions!)
Too small? over-extrude. Too tight? under-extrude. Tolerances are that tight this small.
(photos at the end show the difference in weight from the "cockroach" frame from newbeedrone (which I love) and the acro frame which you'll note does already have the carbon fiber x-brace installed and still comes in lighter!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
