TinyB 100 mm brushless quadcopter

This is a work in progress 100mm brushless micro quad with motor mounts for 1104 motors and able to swing up to 65 mm propellers.

Parts to print
1 x Bottom plate 3 mm
1 x Top plate 1.5 mm
2 x Side plate for aio camera 1 mm


Parts used by me
Motors 1103 8000kv https://goo.gl/Ttl9bO (these have a smaller 8.5 mm mounting pattern but can be used if mounted carefullys since the plastic have some give in it.
Esc 6A Blheli_s https://goo.gl/jCGtEU
Flight controller Picoblx clone https://goo.gl/RhHphW
FPV AIO Camera Aomway hb25t https://goo.gl/sarYd2
Any other small AIO camera should work.
Battery most small 2S should work.
Receiver a micro receiver for your radio

Assembly instructions.
Print 1 bottom plate, 1 top plate and 2 side plates for the top assembly. Use m2 nylon standoffs in an appropriate length to separate top and bottom plate. Secure the aio camera between the two side plates on the top mount using rubber band and double sided tape. Pictures to come.

All fi