Electronics
Model downloaden
TinyG Enclosure for Shapeoko 2
88
Downloads
59
Likes
2
Makes
An enclosure for the TinyG motion controller from Synthetos. Mounts to a Shapeoko 2 endplate. Includes cutouts to run wires to all motor connectors, limit switch connectors, etc. Cutout on the front face is for mounting a fan. It was designed to fit the 24V fan from Inventables. Vent holes on the back are for exhausting the heat sinks on the bottom of the board. I believe the hardware were 4-40 and M2 screws. You may have to drill some of the holes out to get them to fit. I don't have screws installed in the pictures, but I do now, and have been using the enclosure with no problems.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!