Tinyhawk 2 Freestyle full size camera adaptor

This part was designed to allow the installation of a full size FPV camera normally intended for larger quads. The tolerances between the props and the camera are very small, to the point which the blades will cross over the top of these mounts, but should not touch the camera.

THIS PART MUST BE PRINTED IN TPU 92A OR SIMILAR FLEXIBLE FILAMENT. The reason for this is that it replaces the front standoffs and requires the screw holes to be smaller than 2mm. The flexibility allows for a secure fit of the screws. If you print in a rigid filament, you will find yourself fighting to get the screws in.

Designed specifically for the Emax Tinyhawk 2 Freestyle