TinyHawk Freestyle Cam Mount

This mount replaces the standoffs to mount any 14x14mm micro cam. With the camera your looking at adding about 3 grams. Also provides a decent amount of camera protection. You will have to cut a small piece off the bottom front CF frame to allow the camera to fit. This allows to the camera to protrude much less for a cleaner look.

Print with 2 perimeters, 1.5mm height, if using a nozle smaller than .04 make sure to use 100% infill.

I have an Emaxx Nano antenna mount as well: https://www.thingiverse.com/thing:3878308

See the video below for more information,
https://youtu.be/5_DJMvW-GoI