Tinyhawk Freestyle Upgrades

I added ELRS with the ceramic antenna out the diamond in the back of the topper.
Slot in the front accommodates an Eachine Nano vtx .
My hawk has a Caddx Ant , this will work but I removed the plugs and direct soldered everything.
xt30 jams the wiring tight.

I built this to use 20mm standoffs. This is the TALL files. My printer squished quite a bit . I had to add quite a bit to get it to snug in just right.

The Short files are if you aren't running super high standoffs. I don't know how much you'd need to trim or add to get it to fit , but the files are there for you to mod if needed.

Other than that , its a tight , difficult build that has been a royal pain. Figuring out the TPU settings were the easy part. I sliced with PrusaSlicer as Cura kinda sucks. Printed on a mega s with overture tpu.

There are no bumper feet as I found a decent set , that only really needed the motor mount screw holes opened up so it sat flush in the pocket.