Thingiverse
Tinyhawk II Lanyard Adapter
by TWolf07
27
Downloads
16
Likes
1
Makes
Clip on part to allow use of a lanyard (neck strap) with your Emax Radio that comes with the Tinyhawk II ready to fly kit. I believe the Radio controller is the same for each kit (Tinyhawk RTF, Tinyhawk II RTF, Tinyhawk II Freestyle RTF, etc).
I printed on it's side as in the pics and has to have supports. Be patient clipping them off. If your printer is tuned well they should come off clean but I had to use the fillament side cutters. I used 18% support density in Cura on my Ender 3.
Like the original design for the phone holder I remixed it from, you will need 2 rubber bands to secure it to the Radio.
This design still allows for access to the power button and should snug right inbetween the trim buttons. This also allows for removal if needed to take the 18650 battery out of controller.
Hope this helps out :)
I printed on it's side as in the pics and has to have supports. Be patient clipping them off. If your printer is tuned well they should come off clean but I had to use the fillament side cutters. I used 18% support density in Cura on my Ender 3.
Like the original design for the phone holder I remixed it from, you will need 2 rubber bands to secure it to the Radio.
This design still allows for access to the power button and should snug right inbetween the trim buttons. This also allows for removal if needed to take the 18650 battery out of controller.
Hope this helps out :)
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!