Tinylev Stand Modifed for Makerfabs Kit

I saw a demo online of the TInylev ( https://www.instructables.com/id/Acoustic-Levitator/ ) and wanted to build one. Instead of sourcing all the parts individually, I purchased a kit from Makerfabs. https://www.makerfabs.com/index.php?route=product/product&product_id=508

When the kit arrived, I saw the need for a stand. *jeffbearer* uploaded a nice one incorporating all the electronics, so I printed that. The DC jack and switch from the kit were different than he used, so I modified the stand to accept them the old fashioned way; with an X-acto knife. See picture.

For better visibility I drilled some holes in the top and added 3 white LEDs, (1) 5mm top dead center, and (2) 3mm LEDs, one on each side. Each LED was connected to the 9 volt power supply thru a 360 ohm resistor. This required 4 more wires going up the back so I designed a simple conduit that snaps on the center upright and hides the wires. I glued a length of 3/32 aluminum tube in front to keep the top and bottom