TinySine 7800D case

This is a case for the TinySine 7800D amp board. The hinges on the door for the L/R/Sub outs are print-in-place so no assembly necessary past the slipping of the cowl over the footplate. The optical in goes on the same side as the support peg when orienting the board on the footplate. I haven't actually screwed everything together yet but the holes for the posts are 3mm. A 3 mm machine screw *should* do it. The holes for the screws above the audio in are 2 mm. Again, a 2mm machine screw should do it. you'll also need two rubber washers, as two screws will sit against the board without them.

Printed with Black PETG on a BambuLabs A1. Print the cowl upside-down; I recommend printing it with supports for the screw holes, also. I've had mixed results without.

Assembly:
1. Place TinySine 7800D board on footplate, aligning Optical-- In port with the support peg. Place a rubber washer on the screw holes on either side of the analog audio-in ports. Using two 3mm diameter machine screws, sec