Slicer Discord
Tip for Spring Door Stopper – 3D-printbaar model van MakerWorld MakerWorld
Other House Models

Tip for Spring Door Stopper

27 Downloads
5 Likes
23 Makes
Model downloaden
I've spent the last 5 years ignoring the missing tips on my spring door stoppers from cats and children pulling them off and losing them. After searching every hardware store and as much of the internet as I dared, I gave up because someone decided you have to buy a whole new door stopper in order to replace the tip.So I made my own. Print in TPU. Each tip is approximately 1g of material.The inner diameter is 9.3mm and provides a pretty tight fit on the door stopper which is about 9.4mm.It has an air pocket at the end to allow some compression when a door hits it. I did 25% adaptive cubic fill to support this space while leaving it fairly open.
Categorie
Other House Models
Bron
MakerWorld
Gepubliceerd
Bijgewerkt
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Eendelig Hardware nodig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 1/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA, TPU
Nabewerking
Hardware
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie