Tipper Picture Frame

For a 4x6” picture. Should print on most 250x250 printers.

Frame is meant to have color changes at height. BE SURE TO USE CONSENTRIC TOP and BOTTOM LAYERS. This will preserve the "?" styling.

Black or base color until 5mm
Layer 2 (Large ?) 5-5.2mm
Layer 3 (2nd large ?) 5.2- 5.4mm
Layer 4 (Medium ?) 5.4-5.6mm
Layer 5 (Small and Center ?) 5.6-5.8mm
Text 5.8-6mm

The photo attached is using .2mm layer height throughout. So each color on has one layer. If you want to get fancy, I'd suggest switching to .1mm layers after 5mm. This will allow for better color saturation for each individual layer. .2mm layers come out ok but .1mm is just a little better. You could print .1mm for the entire print but switching from .2mm to .1mm at 5mm height will save you a lot of time.

*These files and models are not to be used for commercial use. Any modifications or "remakes" of these files are not to be used for commercial use. Feel free to print and share with your friends and Tipper family, but don'