Thingiverse
Tire lever improved
0
Downloads
1
Likes
0
Makes
The slot that catches on the spoke on the original, is 90 degrees wrong.
i can't see how it would work that way, I'm a bit confused about that.
I didn't try to print the original, I just saw that it was wrong.
Well, I corrected that, and it works good.
I also made a small protrusion on the side of the slot too.
That helps prevent it slipping off the spoke.
i can't see how it would work that way, I'm a bit confused about that.
I didn't try to print the original, I just saw that it was wrong.
Well, I corrected that, and it works good.
I also made a small protrusion on the side of the slot too.
That helps prevent it slipping off the spoke.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
