Slicer Discord
Tissue Box – 3D-Druckmodell von MakerWorld MakerWorld
Other House Models

Tissue Box

48 Downloads
13 Likes
20 Makes
Zum Modell
A Tissue dispenser/box. Made to hold the costco tissues, but I've also fit a box of kleenex balsam tissues in as well. Either use the lid, or use the plate (the black one in the picture) or use them both. I started out with the plunger/plate in the hope it will ensure the next tissue always pop's up even when you get down to the last couple of tissues in the box (1st world problems!). This may or may not work, I'll find out when I get to the bottom of the box.I added the lip part as my partner didn't like the look of just a box without a proper lid. This also means you can add more tissues than will fit in the box and the lid will just slide down as the stack of tissues runs down. You're smart people, I'm sure you'll figure it out.Category: Containers This prints well in PETG and PLA, not tried anything else, but the one in the picture the base is PETG and the lid is PLA.
Kategorie
Other House Models
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA, PETG
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

BobbyDazzler veröffentlicht auch auf

22 zusätzliche Modelle auf 1 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen