Thingiverse
TL-D3 Pro Runout sensor holder
by Sooprman
6
Downloads
3
Likes
0
Makes
Design based off of "Filament switch Tenlog TL-D3 Pro Dual" by hirsch5.
I had a different runout sensor so I made a few changes. I also widened the connection so that the support in the extruder wasn't lost.
You will need to remove the top hex standoff. I used x2 20mm X 3mm screws and nuts to attach to the extruder and x1 25mm X 3mm screw and nut to attach the runout sensor to the mount.
I had a different runout sensor so I made a few changes. I also widened the connection so that the support in the extruder wasn't lost.
You will need to remove the top hex standoff. I used x2 20mm X 3mm screws and nuts to attach to the extruder and x1 25mm X 3mm screw and nut to attach the runout sensor to the mount.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
