MakerWorld
Office
Go to Model
TL-SG1016PE Network Switch Cable Mount
8
Downloads
3
Likes
2
Makes
I needed a design that cleanly managed cables while still allowing easy access to the switch. This design lets the switch slide into place so it sits flush with the rack, while integrated channels guide the cables neatly. The result is a stable setup that routes the wires down behind the shelf it rests on. The status LEDs remain clearly visible, and the power cable exits cleanly from the rear. Assembly is required: the side walls are attached to the top and bottom sections using superglue after printing. I used painters tape to secure while drying. Be sure to us paper to shield the surface on which you're assembling.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
