TL-Smoother Board holder Stackable
von LastWallE
14
Downloads
7
Likes
2
Makes
TL-Smoother Board-Holder for stacking them up.
Just stack the "TL-Smoother_high" up as needed and then the "TL-Smoother_normal" on the top.
I designed the holes with 3.3mm diameter.
from original for stock ender 3: https://www.thingiverse.com/thing:3117672
Type of Smoothers: https://smile.amazon.de/dp/B07GR5SNNG/ref=cm_sw_r_sms_awd_xs_5tzYDbKMS2GYC
Just stack the "TL-Smoother_high" up as needed and then the "TL-Smoother_normal" on the top.
I designed the holes with 3.3mm diameter.
from original for stock ender 3: https://www.thingiverse.com/thing:3117672
Type of Smoothers: https://smile.amazon.de/dp/B07GR5SNNG/ref=cm_sw_r_sms_awd_xs_5tzYDbKMS2GYC
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
